Print This Page Print This Page

Charging System

SAFETY FIRST: Protective gloves and eyewear are recommended at this point.

You will need a digital multimeter to inspect the charging system. Check for loose or corroded connections as you inspect the charging system. If your charging system is having problems complete the following inspection tests from top to bottom.

Battery

YTZ7S YUASA

Inspection

Battery Voltage

Remove the seat. See the Seat topic for more information.

Set the multimeter to read voltage and connect the probes to their respected terminals. The battery should read 13.0 – 13.2 V when fully charged. If the battery reads under 12.3 V it is undercharged.

Current Leakage

Set the multimeter to read amperage.

Loosen the negative battery cable screw with a #2 Phillips head screwdriver. Remove the screw and disconnect the cable from the battery.


. . . .

Login to view the full manual

Gain access to the best repair information for your vehicle, right now!


Existing Member?

This manual is partially open to the public to give a preview of the content. You must be logged in to view the complete manual.

Login Here

If you have a subscription with access to this manual, are logged in, and are still seeing this message refresh this page.

Was this information helpful? How can we improve it?

Your email address will not be published. Required fields are marked *

Table of Contents

Login



Signup Here
Lost Password