Kickstarter Removal
Remove the kickstarter lever.
Remove the oil pump.
Take out the screws holding the right hand engine cover to the crankcase, and remove the cover.
Use circlip pliers to remove the circlip and washer on the kickstarter shaft.
From the outside push the kickstarter shaft into the cover about 6mm (1/4 in.). This will allow the spring to unwind without flying loose. Pull the kickstarter shaft out.
Kickstarter Installation
Slip the shaft into the right hand engine cover from the inside so that the hook on the end of the spring fits into the hook in the cover. The kickstarter should not yet fit all the way into place.
. . . .
REGISTRATION REQUIRED
Gain access to the best repair information for your vehicle, right now!
